LAUDA PRO RP 245 ECooling heating circulator 230 V; 50 Hz L000105

LAUDA PRO RP 245 E Cooling heating circulator 230 V; 50 Hz Features: Thermostatic circulator with latest microprocessor technology. Integrated cooling system Bright and high-contrast graphic OLED display Integrated programmer, 1 programme with max. 20 segments Operation with Cursor- and Softkeys EasyUse system for simple operation of the whole unit SelfCheck Assistant for system diagnosis Command console can be detached and used as remote control Tower design with small footprint Low filling volume enables rapid changes in temperature Bath vessel made of stainless steel (insulated, with overflow and drain tap) LAUDA Varioflex pump (pressure/suction) with 8 selectable levels, connections rear USB and Ethernet interface equipped as standard Retrofittable for upgrading with interface (RS 232/485, Profibus; EtherCAT; analogue or contact modules) Fully electronic continuous controller with PID action for internal & external control PowerAdapt system for the use of the maximum possible amount of heat permitted by the power supply system Low-level and adjustable over-temperature protection with acoustic alarm for use with flammable and non-flammable liquids SmartCool system for energy-saving digital cooling management including compressor on-off control Hybrid cooling system: (heat removal complementary with cooling water) Utilises traditional refrigerants (HFCs) in accordance with European legislation to control F-gases (EU) 517/2014 Technical Features (according to DIN 12876): Working temperature range: -45 ... 200 °C Ambient temperature range: 5 ... 40 °C Temperature stability: 0.05 ±K Heater power max.: 2.5 kW Power consumption max.: 3 kW Power consumption: 13 A Pump Pressure max.: 0.7 bar Pump flow rate pressure max.: 22 L/min In / Outlet connection thread (outside): M16x1 In / Outlet Ø olives: 13 mm Filling volume min.: 2.4 L Filling volume max.: 4.4 L Overall dimensions (WxDxH): 300 x 430 x 675 mm Power supply: 230 V; 50 Hz Power plug: Power cord with angled plug (BS1363) Cooling Capacity (pump stages): 20 °C (8); Ethanol; 0.8 kW 10 °C (8); Ethanol; 0.8 kW 0 °C (8); Ethanol; 0.8 kW -10 °C (8); Ethanol; 0.53 kW -20 °C (4); Ethanol; 0.34 kW -30 °C (4); Ethanol; 0.15 kW -35 °C (4); Ethanol; 0.09 kW -40 °C (4); Ethanol; 0.04 kW -45 °C (2); Ethanol; 0.01 kW Standard Accessory: 2 screw caps, 2 closing plugs 2 nipples 13 mm for pump connectors 2 nipples 10 mm with screw cap G3/8 for cooling water